Cummins — 3666003

C Series Engine Storage - Long Term Section 0 - Complete Engine - Group 00 Page 0-13 NOTE: Using diesel fuel with 0 percent bio components content allows storage for up to 6 months. After 6 months, the engine fuel system must be drained and be flushed again with fresh diesel fuel with 0 percent bio components content. Repeat after each 6-month period. Start the engine. After the engine is operating smoothly, transfer the fuel supply line to the container of calibration fluid or the container of diesel fuel with 0 percent bio components content.

Let the engine run for approximately 25 minutes at low idle in order to ensure that the engine preservative oil (Tectyl™ 910 E or equivalent) is distributed around the engine and its internal components and that the calibration fluid or the diesel fuel with 0 percent bio components content flows out of the injector return line. Turn the engine "OFF". Connect the fuel lines to the fuel filter and the injector return line. Drain all the preservative oil from the engine oil pan sump, the air compressor (if applicable), and drain all the oil filters and all the fuel filters. Install the drain plugs.

CAUTION Before starting another Internal Preservation of the Fuel System procedure again (after passing a storage period ) it is required to fill the engine oil pan sump to the high mark using Tectyl™ 910 or equivalent engine preservative oil. If the engine is being stored as a loose engine, drain the engine coolant and cover all cooling system openings with plastic and tape. If the engine is not being removed from chassis and the engine has an extended life coolant with rust inhibitor, then coolant does not need to be drained.

If the engine will remain in storage for over 24 months, the engine cooling system must be drained and flushed with a suitable solvent or a hot, lightweight mineral oil. Repeat after each 24-month period. Remove the intake and exhaust manifolds. Spray preservative oil into the intake and exhaust ports in the cylinder heads and in the exhaust manifolds only . Do not use preservative oil on the intake manifold or any fuel system components as this may permanently damage sensors or valves. Spray preservative oil in the inlet port on the air compressor (if applicable). Remove the rocker lever covers.

Spray the rocker levers, the valve stems, the springs, the valve guides, the crossheads, and the push rods with preservative oil. Install the rocker lever covers, intake and exhaust manifolds. Brush or spray the preservative oil on all the exposed metal surfaces that are not painted. Preservative oil should not be applied to any plastic, rubber, or similar surfaces. Make sure to coat the flywheel, flywheel housing and all other unpainted machined surfaces with this preservative oil. Use a rust preservative oil compound that meets military specification MIL-C-16173C, type P-2, Grade 1 or 2. For components containing exposed bearings that are not easily accessible e.g.

Fan Hubs, remove the component to aid access. Brush or spray preservative oil on all surfaces that are not painted and refit the component. Use a rust preservative oil compound that meets military specification, MIL-C-16173C, type P-2, Grade 1 or 2 Cover all the openings (engine and components) with heavy paper and tape to prevent dirt and moisture from entering the engine. Cover the entire engine with plastic. Put a warning tag on the engine. The tag must indicate: Do not operate the engine. The engine has been treated with preservatives. Do not bar the crankshaft. The coolant has been removed. The date of treatment. The date of the 6 week inspection if required.