Bearings, Connecting Rod C Series Page 1-6 Section 1 - Cylinder Block - Group 01 Bearings, Connecting Rod (001-005) General Information The connecting rod bearings are a trimetal design with a steel backing. Improper maintenance of the lubrication system is the primary cause of reduced bearing life. An oil analysis will aid in determining the extent of internal engine damage. Refer to Procedure 007-083 in Section 7 for more information. For additional oil analysis, refer to Cummins® Engine Oil and Oil Analysis Recommendations, Bulletin 3810340.
Normally, worn bearings can be detected by reduced oil pressure, but if this wear goes undetected, the excessive clearance will increase the impact between the bearing and crankshaft, causing a distinct knocking sound. A connecting rod noise occurs when the engine is not loaded. Verify by first applying a load and then unloading and listening for the noise.