C Series Bearings, Connecting Rod Section 1 - Cylinder Block - Group 01 Page 1-7 The connecting rod bearing shells are identified by steel- stamped characters on the back of the bearings. The characters indicate either standard (STD) or the amount oversize (OS). Preparatory Steps WARNING To reduce the possibility of personal injury, avoid direct contact of hot oil with your skin. WARNING Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries. To reduce the possibility of arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last.
Some state and federal agencies have determined that used engine oil can be carcinogenic and cause reproductive toxicity. Avoid inhalation of vapors, ingestion, and prolonged contact with used engine oil. WARNING Close the fuel supply valve. Refer to the OEM instructions. Disconnect the batteries. Refer to the OEM service manual. Drain the lubricating oil. Refer to Procedure 007-037 in Section 7. Remove the lubricating oil pan and gasket. Refer to Procedure 007-025 in Section 7. Remove the oil suction tube. Refer to Procedure 007-035 in Section 7.