Bearings, Connecting Rod C Series Page 1-8 Section 1 - Cylinder Block - Group 01 Remove Rotate the crankshaft, using the engine barring gear, Part Number 3377371, to position two of the connecting rods at bottom dead center. Loosen the connecting rod capscrew nuts. Do not remove the capscrew nuts. Hit the connecting rod capscrew nuts with a plastic hammer to loosen the rod caps. The connecting rod bearings must be installed in the same location they were removed from if they are reused. Failure to install the connecting rod bearings in the same location will cause engine damage. CAUTION Remove the connecting rod capscrew nuts and rod cap.
Remove the bearing shell from the rod cap, and mark it as the lower bearing shell from the connecting rod number from where it was removed. Push the connecting rod up far enough to allow the upper bearing shell to be removed. Remove the bearing shell, and mark it as the upper bearing shell and the connecting rod number from where it was removed.