Cummins — 3666003

C Series Bearings, Main Section 1 - Cylinder Block - Group 01 Page 1-13 NOTE: The crankshaft must rotate freely. Check for freedom of rotation as the caps are installed. If the crankshaft does not rotate freely, check the installation of the rod bearings and the bearing size. Finishing Steps Install the oil suction tube. Refer to Procedure 007-035 in Section 7. Install the lubricating oil pan. Refer to Procedure 007-025 in Section 7. Fill the oil pan with clean engine oil. Refer to Procedure 007-037 in Section 7. Connect the batteries. Refer to the OEM service manual. Open the fuel supply valve. Refer to the OEM instructions.

Operate the engine until the coolant temperature reaches 82°C [180°F], and check for leaks and proper operation. Bearings, Main (001-006) General Information The C Series engine has seven main bearings. The lower bearing shells are all the same. The upper bearings do not have holes. All of the upper bearing shells are the same except for the Number 4 journal. The Number 4 journal uses a flanged upper bearing shell. The flanges on the bearing control the end thrust of the crankshaft.