Cummins — 3666003

Bearings, Connecting Rod C Series Page 1-12 Section 1 - Cylinder Block - Group 01 NOTE: Unique serial numbers ( not cylinder numbers) are stamped on the connecting rod and matching connecting rod cap. When the connecting rods and connecting rod caps are installed in the engine, the numbers on the connecting rods and connecting rod caps must match and be installed on the same side of the engine. CAUTION The connecting rod cap number must match the number on the connecting rod and must be installed with the numbers aligned to prevent damage to the connecting rods and the crankshaft. The locking tang of the connecting rod cap must be toward the camshaft side of the cylinder block.

Lubricate under the connecting rod capscrew nuts with clean engine oil. Install the connecting rod caps and rod capscrew nuts. Tighten the connecting rod capscrew nuts in alternating sequence. Torque Value: Step 1 30 N•m [ 22 ft-lb ] Step 2 70 N•m [ 52 ft-lb ] Step 3 60° turn Measure the side clearance between the connecting rod and crankshaft. Connecting Rod Side Clearance mm in 0.10 MIN 0.004 0.33 MAX 0.013