Cummins — 3666003

C Series Bearings, Connecting Rod Section 1 - Cylinder Block - Group 01 Page 1-11 NOTE: Connecting rod bearings are identified with a part number and size stamped on the back. Determine the size of the removed rod bearing and obtain a set of new connecting rod bearings the same size. NOTE: Oversize service rod bearings are available for use with crankshafts that have been machined undersize. See the appropriate parts catalog. Crankshafts that are machined undersize in the connecting rod or main bearing journals are marked on the front counterweight. If the crankshaft is marked, check the bearing shell part number to make sure the correct bearing size is used.

Bearing shells are identified by steel-stamped characters on the back of the bearings to indicate either standard (STD) or amount oversize (OS). Install The connecting rod bearings must be installed in the same location they were removed from if they are reused. Failure to install the connecting rod bearings in the same location will cause engine damage. CAUTION Use clean engine oil to lubricate the crankshaft journal mating surface of the upper bearing shell. Install the upper bearing shell in the connecting rod with the tang of the bearing in the slot of the rod. Pull the connecting rod against the crankshaft to hold the bearing in place.

Install the bearing shell in the connecting rod cap with the tang (2) of the bearing in the slot (1) of the cap. Use clean engine oil to lubricate the bearing shell to crankshaft journal mating surface. Use clean engine oil to lubricate the threads of the connecting rod capscrews.