Bearings, Connecting Rod C Series Page 1-10 Section 1 - Cylinder Block - Group 01 NOTE: Normal bearing wear produces a smooth finish that will wear into the lining. An exposed lining does not always indicate worn bearings. If large areas of the lining are visible in the bearings before the engine has accumulated 240,000 km [150,000 mi] or 3750 hours, inspect the engine for contamination from fine dirt particles, and correct the problem. Inspect the crankshaft rod journals. Refer to Procedure 001-006 in Section 1. Inspect the bearing shell seating surface for nicks or burrs. If nicks or burrs can not be removed with Scotch-Brite™ 7448, Part Number 3823258, the bearings must be replaced. NOTE:
For more detailed information on bearing damage, refer to Analysis and Prevention of Bearing Failures, Bulletin 3810387. Measure the rod bearing shell thickness with an outside micrometer that has a ball tip. Standard Connecting Rod Bearing Thickness (Used) mm in 2.43 MIN 0.096 2.47 MAX 0.097 The bearing must be replaced if it is below the minimum specification.