C Series Bearings, Main Section 1 - Cylinder Block - Group 01 Page 1-17 Using the engine barring tool, Part Number 3377371, rotate the crankshaft so the main bearing rollout tool, Part Number 3823818, pushes against the end of the bearing opposite the tang. Continue rotating the engine to remove the bearing. Follow this procedure to remove the other bearings. CAUTION Use care so the screwdriver does not damage the crankshaft or cylinder block. NOTE: The Number 1 main does not have a hole in the journal, so the bearing rollout tool can not be used to replace the bearing. Use a flat-blade screwdriver. Gently bump the end of the bearing to loosen it from the block.
Then, use finger- pressure against the bearing shell, and rotate the crankshaft to roll the bearing out. Mark the main bearing shell with the letter U (upper) and the journal number from which it was removed.