Bearings, Main C Series Page 1-18 Section 1 - Cylinder Block - Group 01 Clean and Inspect for Reuse When using solvents, acids, or alkaline materials for cleaning, follow the manufacturer's recommendations for use. Wear goggles and protective clothing to reduce the possibility of personal injury. WARNING WARNING Some solvents are flammable and toxic. Read the manufacturer's instructions before using. WARNING Wear appropriate eye and face protection when using compressed air. Flying debris and dirt can cause personal injury. Do not use a scraper or wire brush to clean the main bearing. Bearing damage can occur.
CAUTION Use solvent and a soft bristle brush to clean the cap, capscrews, and bearings. Dry the main bearing caps, capscrews, and main bearings with compressed air. Inspect the main cap and capscrews for damage. Inspect the bearing shells and the thrust bearings for nicks, scratches, or damage. Inspect the main bearings for nicks, scratches, or damage. Replace any bearing with the following damage: Pitting Flaking Corrosion Lock Tang Damage Scratches (deep enough to be felt with a fingernail). NOTE: For more detailed information on bearing damage, refer to Analysis and Prevention of Bearing Failures, Bulletin Number 3810387, or Parts Reuse Guidelines, Bulletin Number 3810303.