C Series Bearings, Main Section 1 - Cylinder Block - Group 01 Page 1-19 Use an outside diameter ball-tipped micrometer to measure the main bearing shell thickness. Standard Main Bearing Shell Thickness mm in 3.446 MIN 0.1357 3.454 MAX 0.1360 Discard any main bearing shell if it is below the minimum specification. NOTE: The upper bearings contain two oil holes. The lower bearings do not . The main bearings are marked on the back to indicate either standard (STD) or oversize (OS). Determine the size of the bearing removed, and obtain the same size for installation. NOTE: Main bearing shells are available for crankshafts that are 0.50 mm [0.020 in] undersize.
Crankshafts that are machined undersize in the connecting rod and main bearing journals are marked on the front counterweight. If the crankshaft is marked, check the bearing shell part number to make sure the correct bearing size is used. Inspect the thrust bearings for wear, cracks, and damage on the front and rear face. Thrust Bearing Inspect the crankshaft journal contact area.