Cummins — 3666003

Bearings, Main C Series Page 1-20 Section 1 - Cylinder Block - Group 01 Measure the thrust bearing flange thickness. Measure both the front and rear flange of the thrust bearing. Thrust Bearing Flange Thickness mm in 3.52 MIN 0.139 3.57 MAX 0.141 NOTE: The thrust bearings are available in 0.25-mm [0.010-in] and 0.50-mm [0.020-in] oversize thicknesses. Install CAUTION The cylinder block saddle and the main bearing cap mating surfaces must be clean and dry when the bearing shells are installed. Used bearings must be installed in their original location. NOTE: Do not lubricate the back of the bearing shell.

Use clean engine oil to lubricate the upper main bearing shell to the crankshaft journal mating surface. Position the new upper main bearing on the crankshaft and install as far as possible by hand. Make sure the pin does not slide under the bearing and damage the crankshaft. CAUTION Use the main bearing rollout tool, Part Number 3823818, and the engine barring tool, Part Number 3377371, to finish pushing the bearing into position. Make sure the upper main bearing is aligned with the block and that the bearing tang aligns with the notch in the cylinder block.