Cummins — 3666003

Camshaft C Series Page 1-28 Section 1 - Cylinder Block - Group 01 Measure the camshaft end play and backlash. Camshaft End Play (A) mm in 0.12 MIN 0.005 0.46 MAX 0.018 Camshaft Gear Backlash (B) mm in 0.08 MIN 0.003 0.33 MAX 0.013 NOTE: Mark the camshaft gear and crankshaft gear for further analysis if the backlash or end clearance exceeds limits. Remove The tappet removal tool kit, Part Number 3822513, contains: 1 Valve tappet tray 2 Dowel rods 3 Rubber bands NOTE: This kit is used to lift the tappets so the camshaft can be removed. 4 Nylon string. Push a wooden dowel rod into each tappet. It will probably be necessary to push the dowel into the tappet with a soft- face hammer.

Pull each valve tappet up until it makes contact with the cylinder block. Put a rubber band around two dowels, this will hold the tappets up off the camshaft. Rotate the crankshaft to align the timing marks before removing the camshaft.