C Series Camshaft Section 1 - Cylinder Block - Group 01 Page 1-27 The camshaft end clearance is determined by the clearance between the camshaft and the thrust plate. The camshaft gear must be removed to adjust the camshaft end clearance. NOTE: The camshaft does not have to be removed to remove the camshaft gear. Use the camshaft gear puller, Part Number 3376400. Camshafts that are damaged or worn on the injector or valve lobes must be replaced. Cummins Inc. does not recommend grinding camshaft lobes. Preparatory Steps Remove the rocker lever cover. Refer to Procedure 003-011 in Section 3. Remove the rocker levers. Refer to Procedure 003-008 in Section 3. Remove the push rods.
Refer to Procedure 004-014 in Section 4. Remove the drive belt. Refer to Procedure 008-002 in Section 8. Remove the vibration damper. Refer to Procedure 001-052 in Section 1. Remove the front gear cover. Refer to Procedure 001-031 in Section 1. Initial Check NOTE: If the camshaft or camshaft gear is replaced due to gear train noise, check the gear train backlash. Excessive gear backlash can be caused by worn camshaft bushings. Position a dial indicator on a tooth of the camshaft gear.