Cummins — 3666003

Camshaft C Series Page 1-30 Section 1 - Cylinder Block - Group 01 After the camshaft has been cleaned, do not touch the machined surfaces with bare hands; this will cause rust to form. CAUTION Lubricate the camshaft with clean engine oil before handling it. Inspect for Reuse NOTE: If a new camshaft is installed on an engine that uses slider tappets, new tappets and push tubes must also be installed. If a new camshaft is installed on an engine that uses roller tappets, only the damaged roller tappets must be replaced. Inspect the valve lobes and bearing journals for wear, cracking, pitting, scratches, and other damage.

The following criteria define the size of the pits, allowable wear, and edge deterioration of the camshaft lobes. Pitting Reuse Criteria A single pit must not be greater than the area of a 2-mm [0.079-in] diameter circle. Interconnection of pits is not allowable and is treated as one pit.