Cummins — 3666003

C Series Camshaft Section 1 - Cylinder Block - Group 01 Page 1-35 To reduce the possibility of personal injury, make sure the camshaft assembly does not drop on your fingers when installing the thrust plate. WARNING Install the camshaft thrust plate. Install and tighten the camshaft thrust plate capscrews. Torque Value: 24 N•m [ 212 in-lb ] Measure camshaft end clearance with a dial indicator. NOTE: End clearance is controlled by the thickness of the thrust plate and the groove in the camshaft. Camshaft End Clearance mm in 0.12 MIN 0.005 0.46 MAX 0.018 NOTE: If the camshaft end clearance is greater than the above limit, the thrust plate must be replaced. NOTE:

Excessive gear backlash can be caused by worn camshaft bushings. Put a dial indicator on the camshaft gear, and check the gear backlash between the camshaft gear and the crankshaft gear. Camshaft Gear Backlash Limits (B) mm in 0.08 MIN 0.003 0.33 MAX 0.013 NOTE: The gears must be replaced if the backlash is greater than the above limit.