Camshaft C Series Page 1-36 Section 1 - Cylinder Block - Group 01 Remove the wooden dowel rods from the valve tappets. Finishing Steps NOTE: Use only Cummins® approved lubricating oil for natural gas engines to prevent premature engine damage. Install the front gear cover. Refer to Procedure 001-031 in Section 1. Install the vibration damper. Refer to Procedure 001-052 in Section 1. Install the drive belt. Refer to Procedure 008-002 in Section 8. Install the push rods. Refer to Procedure 004-014 in Section 4. Install the rocker levers. Refer to Procedure 003-008 in Section 3. Adjust the valve lash. Refer to Procedure 003-004 in Section 3. Install the rocker lever cover.
Refer to Procedure 003-011 in Section 3. Fill the cooling system. Refer to Procedure 008-018 in Section 8. Fill the engine oil. Refer to Procedure 007-037 in Section 7. Operate the engine until the coolant temperature reaches 82° C [180° F]. Check for leaks and proper operation.