C Series Camshaft Bushings Section 1 - Cylinder Block - Group 01 Page 1-37 Camshaft Bushings (001-010) Preparatory Steps Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries. To reduce the possibility of arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last. WARNING WARNING This component or assembly weighs greater than 23 kg [50 lb]. To prevent serious personal injury, be sure to have assistance or use appropriate lifting equipment to lift this component or assembly. Disconnect the battery cables. Refer to Procedure 013-009 in Section 13.
Remove the drive belt. Refer to Procedure 008-002 in Section 8. Remove the rocker lever covers. Refer to Procedure 003-011 in Section 3. Remove the rocker levers. Refer to Procedure 003-008 in Section 3. Remove the push rods. Refer to Procedure 004-014 in Section 4. Remove the vibration damper. Refer to Procedure 001-052 in Section 1. Remove the gear cover. Refer to Procedure 001-031 in Section 1. Remove the camshaft. Refer to Procedure 001-008 in Section 1. Remove Drive the camshaft bushing from the cylinder block bore with camshaft bushing removal and installation tool, Part Number 3165045. The following kits are also available for camshaft bushing installation and removal:
Hydraulic Actuator Kit, Part Number 3823621 Camshaft Bushing Kit, Part Number 3162253