Camshaft Bushings C Series Page 1-38 Section 1 - Cylinder Block - Group 01 Clean When using solvents, acids, or alkaline materials for cleaning, follow the manufacturer's recommendations for use. Wear goggles and protective clothing to avoid personal injury. WARNING Use a fine emery cloth and solvent to remove any burrs and sharp edges from the camshaft bushing bores. Install Mark the camshaft bushing and cylinder block to aid in the alignment of align the lubricating oil hole in the cylinder block with the lubricating oil hole in the bushing. NOTE: The top hole on the front and rear camshaft bushings will not line up with the top hole of the cylinder block bores.
Only the botton hole will be line up for the front and rear camshaft bushings. Use the camshaft bushing installation and removal tool, Part Number 3165045, to install the camshaft bushing so that it is even with the front face of the cylinder block. For ease of bushing installation use Hydraulic Actuator Kit, Part Number 3823621, and Camshaft Bushing Kit, Part Number 3162253. NOTE: The front camshaft bushing must be installed to a depth of 4.5 mm [0.177 in] below the front face of the cylinder block. All other bushings must be installed even with the web of the camshaft bores. For the front and rear camshaft bushings, only the bottom hole will line up with the hole in the cylinder block.
Make sure the lubricating oil hole is aligned. A 3.2 mm [0.128 in] diameter rod must be able to pass freely through the camshaft bushing oil hole.