C Series Camshaft Gear (Camshaft Removed) Section 1 - Cylinder Block - Group 01 Page 1-43 The gear will be permanently distorted if overheated. The oven temperature must never exceed the specification. CAUTION Tempered Camshaft Gear NOTE: The steel camshaft, Part No. 3918777, uses a dowel pin. The cast-iron camshaft, Part No. 3924471, uses a Woodruff key. Temperature 149 °C [ 300 °F ] WARNING Wear protective gloves to prevent personal injury when handling parts that have been heated. Install the camshaft gear with the timing marks away from the camshaft. To prevent engine damage, the timing marks and gear part number must be facing away from the camshaft when the gear is installed.
Keep the camshaft in a vertical position with the gear up until the gear has cooled. Do not use water to reduce the cooling time. Using water will crack the gear. NOTE: The gear must be installed within 30 seconds after it is removed from the oven. CAUTION Remove the gear from the oven. Align the keyway in the gear with the dowel pin in the camshaft; install the gear on the camshaft. Make sure the gear is seated against the camshaft shoulder. Finishing Steps Install the camshaft. For C Series diesel engines, refer to Procedure 001-008 in Troubleshooting and Repair Manual, C Series Engines, Bulletin 3666003.
For C Series natural gas engines, refer to Procedure 001-008 in Troubleshooting and Repair Manual, C8.3G (Natural Gas) Engines, Bulletin 3666206. Install the front gear cover. Refer to Procedure 001-031. Install the vibration damper. Refer to Procedure 001-052. Install the fan pulley. Refer to Procedure 008-039. Operate engine and check for leaks.