Connecting Rod C Series Page 1-44 Section 1 - Cylinder Block - Group 01 Connecting Rod (001-014) Preparatory Steps Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries. To reduce the possibility of arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last. WARNING WARNING Coolant is toxic. If not reused, dispose of in accordance with local environmental regulations. WARNING Some state and federal agencies have determined that used engine oil can be carcinogenic and cause reproductive toxicity.
Avoid inhalation of vapors, ingestion, and prolonged contact with used engine oil. This component or assembly weighs greater than 23 kg [50 lb]. To prevent serious personal injury, be sure to have assistance or use appropriate lifting equipment to lift this component or assembly. Close the fuel supply valve. Refer to the OEM instructions. Disconnect the batteries. Refer to Procedure 013-009 (Battery Cables and Connections) in Section 13. Drain the coolant. Refer to Procedure 008-018 (Cooling System) in Section 8. Remove the cylinder head. Refer to Procedure 002-004 (Cylinder Head) in Section 2. Drain the lubricating oil. Refer to Procedure 007-037 (Lubricating Oil System) in Section 7.
Remove the lubricating oil pan and gasket. Refer to Procedure 007-025 (Lubricating Oil Pan) in Section 7. Remove lubricating oil suction tube. Refer to Procedure 007-035 (Lubricating Oil Suction Tube (Block-Mounted)) in Section 7. Remove and disassemble the piston and connecting rod assemblies. Refer to Procedure 001-054 (Piston and Connecting Rod Assembly) in Section 1. WARNING