Cummins — 3666003

C Series Connecting Rod Section 1 - Cylinder Block - Group 01 Page 1-45 Clean and Inspect for Reuse The letter or number on the connecting rod cap must be the same as the letter or number on the connecting rod. Do not assemble a new cap to a used connecting rod, or a used cap to a new connecting rod. Remove the connecting rod capscrew nuts and caps from the connecting rods. WARNING When using a steam cleaner, wear protective clothing and safety glasses or a face shield. Hot steam can cause serious personal injury. When using solvents, acids, or alkaline materials for cleaning, follow the manufacturer's recommendations for use.

Wear goggles and protective clothing to reduce the possibility of personal injury. WARNING WARNING Wear appropriate eye and face protection when using compressed air. Flying debris and dirt can cause personal injury. Use solvent or steam to clean the rods. Use a soft bristle brush to clean the oil drilling. Dry with compressed air. Inspect the connecting rod and cap for fretting damage on the mating surfaces. The rod and cap must be replaced as an assembly if any fretting damage is visible on either piece. Replace the connecting rod if the I-beam is nicked or damaged.