Cummins — 3666003

C Series Connecting Rod Section 1 - Cylinder Block - Group 01 Page 1-47 Install the bearing shells into the connecting rod and cap. Use clean 15W-40 oil to lubricate the capscrew threads. Install the connecting rod caps and connecting rod nuts. The connecting rod cap number must match the number on the connecting rod and be installed with the numbers aligned. Tighten the connecting rod nuts in alternating sequence. Torque Value: Step1 40 N•m [ 30 ft-lb ] Step2 80 N•m [ 60 ft-lb ] Step3 120 N•m [ 88 ft-lb ] Measure the connecting rod crankshaft bore inside diameter. Connecting Rod Crankshaft Bore I.D. (With Bearing) mm in 76.04 MIN 2.9939 76.104 MAX 2.9962 Connecting Rod Crankshaft Bore I.D.

(Without Bearing) mm in 80.987 MIN 3.1885 81.013 MAX 3.1895 The connecting rod must be assembled with the capscrew nuts tightened to specifications before stamping the cylinder identification number on the connecting rod. If a new connecting rod is installed, always stamp the new connecting rod with the cylinder number of the rod being replaced. Bend and Twist Inspect Calibration Procedure Use a connecting rod checking fixture, Part Number ST-561, and a connecting rod mandrel set, Part Number 3823286, to inspect the bend and twist of the rods. Calibrate the checking fixture with a new rod that has been measured for correct center to center length, 215.975 to 216.025 mm [8.5029 to 8.5040 in].

Assemble the connecting rod cap to the rod as described previously in this procedure.