Cummins — 3666003

Connecting Rod C Series Page 1-48 Section 1 - Cylinder Block - Group 01 Install the piston pin mandrel from the connecting rod mandrel set, Part Number 3823286, into the piston pin bore. NOTE: Use a mandrel, Part Number 3823283, if the piston bushing has been removed or mandrel, Part Number 3823284, if the bushing is still in place. Install the mandrel, Part Number 3823303, into the crankshaft bore and expand the mandrel. NOTE: Make sure the pin on the mandrel is pointed down and locked in position in the center of the connecting rod. Install the connecting rod into the fixture. Move the dial holder to position the contact points of the indicators on the mandrel in the piston pin bore.

Tighten the bracket to hold the indicators in position. Set the dial indicators to read zero. Remove the connecting rod from the fixture. Turn the rod 180 degrees horizontally, and install the rod into the fixture again. Check the dial indicators for the zero position again. If the dial indicators show any change from zero, adjust the dials to half the indicated reading. The fixture is now calibrated to allow the connecting rod to be installed into the fixture in either direction, and the dials will indicate an equal deflection on either side or zero.