Cummins — 3666003

Connecting Rod C Series Page 1-52 Section 1 - Cylinder Block - Group 01 Measure the connecting rod bushing bore with the bushing removed. NOTE: If the connecting rod bushing bore is not within specifications, replace the connecting rod. Connecting Rod Piston Pin Bore Diameter (Bushing Removed) mm in 48.988 MIN 1.9286 49.012 MAX 1.9296 Before installing the connecting rod bushing, submerge the bushing and connecting rod pin end in clean 15W-40 engine oil. Place the connecting rod bushing on the mandrel. Match the angles, place the angle side down and align the notch of the knock-out (thin ring) to the pin in the driver ring and slide on the mandrel.

Place the knock-out (thin ring) inside the driver ring.