Cummins — 3666003

C Series Connecting Rod Section 1 - Cylinder Block - Group 01 Page 1-53 Install the cap and secure with the hair pin cotter pin. Insert the mandrel and components into the chamfered side of the connecting rod. Align the angles of the bushing, connecting rod, and stop rings. NOTE: Not all connecting rods have a double chamfer. A chamfer can be added to aid in the installation of the bushing, but must not result in an unsupported bushing area. Align the oil hole in the bushing and connecting rod (use the groove in the mandrel) and push the mandrel and components into the pin bore of the connecting rod until contact is made. This contact helps maintain the alignment of the oil holes.

Place the connecting rod and mandrel assembly on the anvil. Position it so that the angle on the connecting rod matches the angle on the anvil. The connecting rod is in the horizontal position.