Cummins — 3666003

Connecting Rod C Series Page 1-54 Section 1 - Cylinder Block - Group 01 Press the bushing into the connecting rod by applying force on the top of the cup. Use either an arbor or hydraulic press. Push through in a continuous motion until the driver ring makes contact with the connecting rod. Check the alignment of the oil holes. A 3 mm [0.118 in] diameter rod must move freely through the connecting rod and the bushing oil holes (A). Check for clearance between the connecting rod bushing and the connecting rod. Use a 0.025 mm [0.001 in] feeler gauge to make sure the bushing is properly seated. The 0.025 mm [0.001 in] feeler gauge must not enter between the bushing and the connecting rod (B).

Machine The inside diameter of new connecting rod bushings must be machined with a rod boring machine, such as Part Number 3823601 (Sunnen PM-300®) or Part Number 3375144 (Tobin Arp®). When properly adjusted, a Sunnen PM-300®, or equivalent, connecting rod boring machine is capable of maintaining all the critical dimensions. Do not use a ”floating rod" type honing machine. After machining the connecting rod bushings, it will be necessary to check all critical dimensions. See the instructions within this procedure.