C Series Crankshaft Section 1 - Cylinder Block - Group 01 Page 1-55 Finishing Steps Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries. To reduce the possibility of arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last. Assemble and install the piston and connecting rod assemblies. Refer to Procedure 001-054 (Piston and Connecting Rod Assembly) in Section 1. Install the lubricating oil suction tube. Refer to Procedure 007-035 (Lubricating Oil Suction Tube (Block-Mounted)) in Section 7. Install the lubricating oil pan and gasket.
Refer to Procedure 007-025 (Lubricating Oil Pan) in Section 7. Install the cylinder head. Refer to Procedure 002-004 (Cylinder Head) in Section 2. Fill the lubricating oil pan. Refer to Procedure 007-037 (Lubricating Oil System) in Section 7. Fill the cooling system. Refer to Procedure 008-018 (Cooling System) in Section 8. Connect the batteries. Refer to Procedure 013-009 (Battery Cables and Connections) in Section 13. Open the fuel supply valve. Refer to the OEM instructions. Operate the engine to normal operating temperature and check for leaks. WARNING Crankshaft (001-016) General Information The crankshaft uses forged counterweights.
Oversize main bearings and thrust bearings are available for service. Cummins Engine Company, Inc., recommends regrinding all of the main or the connecting rod journals when one requires regrinding. Refer to the C Series Shop Manual, Bulletin No. 3666008. Preparatory Steps WARNING Some state and federal agencies have determined that used engine oil can be carcinogenic and cause reproductive toxicity. Avoid inhalation of vapors, ingestion, and prolonged contact with used engine oil. Drain the lubricating oil; refer to Procedure 007-037.