C Series Crankshaft Section 1 - Cylinder Block - Group 01 Page 1-57 Remove the main bearings; refer to Procedure 001-006. Remove WARNING This component weighs 23 kg [50 lb] or more. To avoid personal injury, use a hoist or get assistance to lift this component. NOTE: Lift the crankshaft straight up to avoid damage to the crankshaft and cylinder block. Install nylon lift sling, Part No. 3375957, around the No. 3 and No. 4 rod bearing journals. Attach the sling to a hoist; remove the crankshaft. Clean Use fine crocus cloth to polish the machined surfaces. Use a bristle brush to clean the oil drillings. When using a steam cleaner, wear protective clothing and safety glasses or a face shield.
Hot steam will cause serious personal injury. WARNING Steam-clean the crankshaft and dry with compressed air. Make sure to blow out the threaded holes on each end of the crankshaft and the oil drillings.