Crankshaft C Series Page 1-58 Section 1 - Cylinder Block - Group 01 Inspect for Reuse Use one of the following methods to repair any threaded holes: Chase the threads Use the threaded insert kit, Part Number 3822709. NOTE: If more than two threaded holes are damaged in one end, the crankshaft must be replaced. Inspect the threaded capscrew holes for damage. Measure the front and rear oil seal contact areas for a wear groove. Crankshaft Front and Rear Oil Seal Wear Groove mm in 0.25 MAX 0.010 Front and rear wear sleeves are available for a crankshaft that is worn beyond the limit. Inspect the crankshaft connecting rod and main journals for deep scoring, overheating, etc.