Cylinder Liner C Series Page 1-76 Section 1 - Cylinder Block - Group 01 Initial Check NOTE: Before removing the cylinder liners, inspect the condition to determine reusability. Inspect the inside of the liner for cracking, scuffing, or scoring. Inspect the inside for vertical scratches deep enough to be felt with a fingernail. NOTE: If a fingernail catches in a scratch, the liner must be replaced. Inspect the inside of the liner bore for polishing. NOTE: A moderate polish produces a bright mirror finish in the worn area with traces of the original hone marks or an indication of an etch pattern. NOTE:
A heavy polish produces a bright mirror finish in the worn area with no traces of hone marks or an etch pattern. Do not reuse liners that have heavy polish or any indications of particle embedment from failure. Inspect the liners for a ridge near the top of the liner. Severely worn liners will have a ridge near the top of the liner bore. If the wear pattern indicates the liner bore is not straight or not round, use a dial bore gauge to measure the liner inside diameter in four places 90 degrees apart at the top and bottom of the piston travel area. Cylinder Liner Dimensions mm in Out of Round 0.04 MAX 0.002 Taper 0.04 MAX 0.002 Bore Diameter 114.04 MAX 4.490 NOTE:
If the liner bore is not acceptable for reuse, it must be replaced. Damaged liners can not be honed or deglazed. This will destroy the crosshatch pattern needed for oil control. NOTE: Do not remove or disturb the liner seals for liners that pass the inspection criteria.