C Series Cylinder Liner Section 1 - Cylinder Block - Group 01 Page 1-77 Cylinder liner protrusion is the distance the liner protrudes above the block face. Before removing the liners, check the protrusion, use the liner protrusion gauge, Part Number 3823495, in the unclamped state. Cylinder Liner Protrusion mm in New Block and Liners 0.025 MIN 0.001 0.122 MAX 0.005 Used Block and Liners 0.000 MIN 0.000 0.122 MAX 0.005 New Block Used Liners 0.025 MIN 0.001 0.122 MAX 0.005 Used Block New Liners 0.000 MIN 0.000 0.122 MAX 0.005 NOTE:
If the liner was installed correctly and the liner protrusion is out-of-limits, it will be necessary to machine the counterbore and add shims to restore to the original specifications. Remove NOTE: Use clean shop rags to cover the crankshaft to prevent debris from falling into the main journal area or into the connecting rod journal oil drilling. CAUTION The liner puller must be installed and used as described to avoid damage to the cylinder block. The puller must not contact the block casting at points (1), (2), (3), or (4). Insert the cylinder liner puller, Part Number 3376015, into the top of the cylinder block.