Cylinder Liner C Series Page 1-78 Section 1 - Cylinder Block - Group 01 NOTE: The liner puller must be centered on the top of the cylinder block. Turn the puller jackscrew clockwise to loosen the liner from the cylinder block. Use both hands to remove the liner. Mark the cylinder number on each liner. Clean and Inspect for Reuse Do not use any abrasives in the ring travel area of the liner. The liner can be damaged. CAUTION Use a soft wire brush or a fine fibrous abrasive pad such as Scotch-Brite® 7448, Part Number 3823258, to clean the flange seating area.