Cummins — 3666003

Cylinder Liner C Series Page 1-86 Section 1 - Cylinder Block - Group 01 Service Tip: If the out-of-limit condition is minimal, tolerance stackup will allow the protrusion limits to be obtained by installing other new liners in the out-of-limit bore. NOTE: If the liner protrusion still does not meet the specifications, machine the cylinder block liner bore for shims. Use a feeler gauge to inspect the liner to block clearance at the four block casting points. Cylinder-Liner-to-Block Clearance mm in 0.23 MIN 0.009 NOTE: If the clearance is less than 0.23 mm [0.009 in]: Inspect the liner and cylinder block for dirt or damage. Remove the liner.