Cummins — 3666003

C Series Cylinder Liner Section 1 - Cylinder Block - Group 01 Page 1-87 Replace the liner if it is damaged. Install the liner again. Measure the liner bore for out-of-roundness at points (C), (D), (E), (F), and (G). Measure each point in the direction (AA) and (BB). The bore must not be more than 0.08-mm [0.003-in] out of round. NOTE: If the bore is more than 0.08-mm [0.003-in] out of round: Remove the liner so the cylinder block liner bore can be measured.