Cummins — 3666003

Gear Cover, Front C Series Page 1-88 Section 1 - Cylinder Block - Group 01 Finishing Steps Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries. To reduce the possibility of arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last. NOTE: Do not interchange pistons from the original cylinder location. WARNING Install the piston and connecting rods. Refer to Procedure 001-043 in Section 1. Install the lubricating oil pan and suction tube. Refer to Procedure 007-025 in Section 7. Install the cylinder head. Use the following procedure for C Series diesel engines.

Refer to Procedure 002-004 in Section 2. Fill the cooling system. Refer to Procedure 008-018 in Section 8. Fill the lubricating system. Refer to Procedure 007-037 in Section 7. Connect the batteries. Refer to Procedure 013-009 in Section 13. Open the fuel supply valve. Refer to the OEM instructions. Operate the engine until the coolant temperature reaches 82°C [180°F], and check for leaks and proper operation. Gear Cover, Front (001-031) Preparatory Steps WARNING Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries.

To reduce the possibility of arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last. Close the fuel supply valve. Refer to the OEM instructions. Disconnect the batteries. Refer to Procedure 013-009 in Section 13. Remove the fan drive belt. Refer to Procedure 008-002 in Section 8. Remove the fan pulley and spacer. Refer to Procedure 008-039 in Section 8. Remove the vibration damper and pulley. Refer to Procedure 001-052 in Section 1. Remove the crankshaft oil seal dust shield, if used.