Gear Cover, Front C Series Page 1-90 Section 1 - Cylinder Block - Group 01 Inspect the gear cover for cracks, dents, and other damage. Inspect the sealing surface of the crankshaft for wear. If the crankshaft has a groove due to the oil seal, a wear sleeve must be used to prevent seal leakage. Assemble Install a new crankshaft seal. Refer to Procedure 001-023 in Section 1. Install NOTE: Do not remove the plastic seal pilot tool from the lubricating oil seal at this time. Use the plastic seal pilot tool to guide the seal on the crankshaft. NOTE: Install three guide pins, Part Number 3164977, to improve alignment of the front cover and front seal to the gear housing and crankshaft.
Apply a 4-mm wide bead of ThreeBond, Part Number 3823494, along the entire flange of the gear cover. Follow the grooves in the flange; circle all of the capscrew holes with ThreeBond, Part Number 3823494. Do not use a paper gasket with the gear cover. NOTE: The front cover must be installed and the capscrews tightened within 15 minutes from when the ThreeBond was applied. If the ThreeBond, Part Number 3823494, appears skinned over, it will not create a good seal. It must be cleaned from the front cover and new ThreeBond, Part Number 3823494, applied.