Cummins — 3666003

C Series Gear Housing, Front Section 1 - Cylinder Block - Group 01 Page 1-91 Install the front gear cover and tighten the capscrews. Tighten the long cover capscrews with 11-mm heads to: Torque Value: 40 N•m [ 30 ft-lb ] Tighten the short cover capscrews with the 10-mm heads to: Torque Value: 30 N•m [ 22 ft-lb ] Remove the plastic pilot tool from the crankshaft. Finishing Steps WARNING Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries. To reduce the possibility of arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last.

Install the crankshaft oil seal dust shield, if used, as follows: Push the dust shield onto the crankshaft with the part number facing out away from the engine. The dust shield must contact the oil seal. NOTE: No lubrication is required for installation. Install the vibration damper and pulley. Refer to Procedure 001-052 in Section 1. Install the fan pulley and spacer. Refer to Procedure 008-039 in Section 8. Install the fan drive belt. Refer to Procedure 008-002 in Section 8. 4 Connect the batteries. Refer to Procedure 013-009 in Section 13. Open the fuel supply valve. Refer to the OEM instructions. Operate the engine 5 to 10 minutes to check for leaks and proper operation.

Gear Housing, Front (001-033) General Information Front Gear Housing and Gear Train Troubleshooting the front gear housing and gear train consists of checking for leaks at the gaskets (front cover, timing pin assembly, and fuel injection pump) and the front crankshaft lubricating oil seal, inspecting the gears, and measuring backlash, when required. Replace the front crankshaft oil seal. Refer to Procedure 001-023 (Crankshaft Seal, Front) in Section 1.