Cummins — 3666003

Gear Housing, Front C Series Page 1-96 Section 1 - Cylinder Block - Group 01 If the fuel injection pump studs are damaged or being installed in a new housing, coat the threads with Loctite® 242. Use two nuts, locked together, to remove and install the studs. If the gear housing is being replaced, remove the engine data plate and install it on the new gear housing. Refer to Procedure 001-057 (Engine Data Plate) in Section 1. Install The gear housing oil pan capscrews must be tightened within 15 minutes after applying the sealant. Inspect the oil pan gasket. If it is not torn, apply Three- Bond™ RTV sealant, Part Number 3823494, around the capscrew holes and at the joint of the gear housing.

If the pan gasket is torn, it can be repaired. Cut the torn gasket off even with the front of the cylinder block.