Cummins — 3666003

C Series Gear Housing, Front Section 1 - Cylinder Block - Group 01 Page 1-97 Use the old gasket as a pattern, cut the front section of a new gasket to the same size. The gear housing and oil pan must be installed and tightened within 15 minutes after applying the sealant. Clean the sealing surfaces and coat the new gasket on both sides with Three-Bond™ RTV sealant, Part Number 3823494. Use thread or a very fine wire to hold the new gasket splice in position as illustrated. Mark and trim 1.6 mm [0.063 in] off the new gear housing gasket. When properly trimmed, the gear housing gasket must be even with the lubricating oil pan gasket when installed.