Gear Housing, Front C Series Page 1-98 Section 1 - Cylinder Block - Group 01 Position the gasket on the alignment dowels. Use guide pins (M8 x 1.25 x 50) to assist in aligning the gasket and gear housing. Make sure the guide pins are removed after alignment. Carefully install the gear housing, making sure both gaskets are in place. Install and tighten the gear housing mounting capscrews. Torque Value: 24 N•m [ 212 in-lb ] Start the oil pan capscrews in the holes not being used to tie the gasket in place. Remove the thread or wire holding the gasket in place.