C Series Piston Section 1 - Cylinder Block - Group 01 Page 1-99 Install the remaining two capscrews. Tighten the oil pan capscrews. Torque Value: 24 N•m [ 212 in-lb ] Finishing Steps Install the tappets. Refer to Procedure 004-015 (Tappet) in Section 4. Install the camshaft and camshaft thrust washer. Refer to Procedure 001-008 (Engine Mounting Bolts) in Section 1. Install the push rods. Refer to Procedure 004-014 (Push Rods or Tubes) in Section 4. Install the rocker levers. Refer to Procedure 003-008 (Rocker Lever) in Section 3.Adjust the valves. Refer to Procedure 003-004 (Overhead Set) in Section 3. Install the rocker lever cover.
Refer to Procedure 003-011 (Rocker Lever Cover) in Section 3. Install the accessory drive or air compressor. Refer to Procedure 012-014 (Air Compressor) in Section 12.. Install the front gear cover. Refer to Procedure 001-031 (Accessory Drive Seal) in Section 1.Install the vibration damper. Refer to Procedure 001-052 (Vibration Damper, Viscous) in Section 1. Install the drive belt. Refer to Procedure 008-002 (Drive Belt, Cooling Fan) in Section 8.. Operate the engine at idle for 5 to 10 minutes and check for leaks. Piston (001-043) Initial Check Compression Gauge and Adapter It is very time consuming and expensive to begin removing internal engine components to diagnose failures.
A compression gauge can be used as an aid to check for proper functioning of the following components: