Cummins — 3666003

Piston C Series Page 1-100 Section 1 - Cylinder Block - Group 01 1 Piston ring sealing 2 Intake and exhaust valve sealing 3 Cylinder head gasket sealing 4 Cylinder head cracked. See the appropriate procedure in this manual for replacement of failed components. NOTE: Due to variables such as starter and battery conditions that affect engine cranking speed, it is difficult to establish an absolute value for compression pressure; however, the following values can be used as guidelines: New engine (cranking speed at 250 rpm) 2413 kPa [350 psi] Used engine (cranking speed at 250 rpm) 2068 kPa [300 psi]. It is recommended that the compression pressure be checked on all cylinders and then compared.

All cylinders should be within 690 kPa [100 psi] of each other. Piston Ring Sealing If the compression is low but can be increased significantly by squirting oil into the cylinder, the cause of low compression is inadequate sealing between the rings and the cylinder walls. Use the following procedure for piston ring replacement. Refer to Procedure 001-047 in Section 1. If the compression is low on one or more nonadjacent cylinders and the pressure can not be increased by oiling the rings, poor valve sealing is to be suspected. Intake and Exhaust Valve Sealing Refer to Procedure 002-004 in Section 2.