C Series Vibration Damper, Viscous Section 1 - Cylinder Block - Group 01 Page 1-117 Spray the damper with spot check developer, type SKD- NF, or its equivalent. Heat the damper in an oven, rolled-lip side down, at 93°C [200°F] for 2 hours. WARNING Wear protective gloves to reduce the possibility of personal injury when handling parts that have been heated. Remove the damper from the oven and check for fluid leakage. If there is any leakage, the vibration damper must be replaced. Install NOTE: Align the vibration damper/crankshaft speed indicator ring assembly with the index pin located on the nose of the crankshaft. Lubricate the capscrews with clean engine oil.
Install the vibration damper/crankshaft speed indicator ring assembly. Tighten the six vibration damper capscrews in a criss- cross pattern. Torque Value: Step 1 50 N•m [ 37 ft-lb ] Step 2 Rotate 90 degrees