Piston and Connecting Rod Assembly C Series Page 1-118 Section 1 - Cylinder Block - Group 01 Finishing Steps Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries. To reduce the possibility of arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last. WARNING Install the drive belt. Refer to Procedure 008-002 in Section 8. Connect the batteries. Refer to the OEM service manual. Operate the engine and check for noise and proper operation.
Piston and Connecting Rod Assembly (001-054) General Information There are a number of power-related problems, including excessive lubricating oil consumption, smoke, blowby, and poor performance that can be caused by inadequate sealing between the piston rings and the cylinder walls. A blowby measurement can help to detect these problems. A free-floating, hollow piston pin is used to attach the piston to the connecting rod. Lubrication of the pin and journal is accomplished by residual spray from piston cooling. The piston pin end of the connecting rod is angle-cut to provide additional bearing surface. The connecting rod end is fitted with a bronze bushing.