Cummins — 3666003

C Series Piston and Connecting Rod Assembly Section 1 - Cylinder Block - Group 01 Page 1-119 Preparatory Steps Some state and federal agencies have determined that used engine oil can be carcinogenic and cause reproductive toxicity. Avoid inhalation of vapors, ingestion, and prolonged contact with used engine oil. WARNING Do not remove the pressure cap from a hot engine. Wait until the coolant temperature is below 50°C [120°F] before removing the pressure cap. Heated coolant spray or steam can cause personal injury. WARNING Coolant is toxic. If not reused, dispose of in accordance with local environmental regulations. WARNING This component or assembly weighs greater than 23 kg [50 lb].

To prevent serious personal injury, be sure to have assistance or use appropriate lifting equipment to lift this component or assembly. WARNING Drain the lubricating oil. Refer to Procedure 007-037 in Section 7. Drain the coolant. Refer to Procedure 008-018 in Section 8. Remove the lubricating oil pan. Refer to Procedure 007-025 in Section 7. Remove the cylinder head. Refer to Procedure 002-004 in Section 2. Mark each connecting rod cap according to cylinder. Remove Rotate the crankshaft with engine barring tool, Part Number 3377371, until the pistons are below the carbon deposits that are found above the ring travel area.