Piston and Connecting Rod Assembly C Series Page 1-120 Section 1 - Cylinder Block - Group 01 Do not use emery cloth or sandpaper to remove carbon from the cylinder liners. Aluminum oxide or silicon particles from emery cloth or sandpaper can cause serious engine damage. Do not use any abrasives in the ring travel area. The cylinder liner can be damaged. CAUTION Use a scraper or a blunt-edged instrument to loosen the carbon deposits. Do not damage the cylinder liner with the scraper. NOTE: Only scrape or sand above the piston travel area. WARNING When using solvents, acids, or alkaline materials for cleaning, follow the manufacturer's recommendations for use.
Wear goggles and protective clothing to avoid personal injury. Remove the remaining carbon with Scotch-Brite™ 7448 abrasive pad, Part Number 3823258, and solvent. Rotate the crankshaft to position the connecting rod caps just before Top Dead Center for removal. NOTE: Do not remove the capscrews from the connecting rods. Loosen the connecting rod capscrew nuts. Use a plastic hammer to hit the connecting rod capscrews to loosen the connecting rod caps. Remove the capscrew nuts, connecting rod cap, and connecting rod bearings. Mark the connecting rod bearings with the cylinder number and “U” for the upper bearing and “L” for the lower bearings.