Cummins — 3666003

C Series Piston and Connecting Rod Assembly Section 1 - Cylinder Block - Group 01 Page 1-121 Use the T-handle piston pusher to push the rod away from the crankshaft. NOTE: Push the rod until the piston rings are outside the top of the cylinder liner. Use both hands to remove the piston and rod assembly. NOTE: The piston and connecting rod assemblies must be installed in the same cylinder from which they were removed. This will allow for the proper fit of worn mating surfaces if the parts are used again. Use a tag to mark the cylinder number from which each piston and rod assembly was removed. Place the connecting rod and piston assemblies in a container to protect them from damage.

Disassemble Remove the piston pin retaining rings.