C Series Piston and Connecting Rod Assembly Section 1 - Cylinder Block - Group 01 Page 1-123 Lubricate the piston pin and piston pin bores with clean engine oil. NOTE: Pistons do not require heating to install the pin; however, the pistons do need to be at room temperature or above. Install the piston pin. Install the second piston pin retaining ring. When rebuilding an engine with the original cylinder block, crankshaft, and pistons, make sure the pistons are installed in the original cylinder. If replacing the piston(s), make sure the replacement piston(s) is the same grade as the original piston.
If a new cylinder block or crankshaft is used, the piston grading procedure must be performed to determine the proper piston grade for each cylinder. Piston Grading Install the connecting rod/piston assembly into the Number 1 cylinder without the rings installed.