Piston and Connecting Rod Assembly C Series Page 1-124 Section 1 - Cylinder Block - Group 01 NOTE: The connecting rod bearings must be installed in the original connecting rod and cap. Install the upper bearing shell in the connecting rod with the tang of the bearing in the slot of the connecting rod. Use clean lubricating oil to coat the inside of the connecting rod bearing shell. Install the bearing shell in the connecting rod cap with the tang of the bearing in the slot of the cap. Use clean lubricating oil to coat the inside diameter of the connecting rod bearing shell.
The four-digit number stamped on the connecting rod and cap at the parting line must match and be installed on the same side in all cylinders. Install the connecting rod cap and capscrews to the connecting rod. NOTE: The word FRONT on the piston will now be toward the front of the block. The combustion bowl in the piston will be on the fuel pump side of the engine. Tighten the two connecting rod capscrews. Torque Value: 40 N•m [ 30 ft-lb ]